Develop A Simple Planter Box

Sharing is caring!

Love flowers, but do not have the space — or maybe the desire — to grow a garden? You might wish to try creating your own flower box that is usually almost any size you want.

This planter box is made with a top along with a bottom exterior frame; then you affix cedar sections with the frame and also increase bottom panels. And then, simply add crops for a touch of springtime wherever you wish to place it!

Expert tip: Always bring a diagram before you develop anything. Remember: In case you cannot bring it, you cannot build it! You do not need to be Leonardo Divinci simply that you are able to read through it!! The diagram of yours is going to be helpful in helping you figure out the size of the project of yours and also the quantity of lumber you will need. Just take the completed diagram with you whenever you go shopping, and you will be sure to get anything your project needs.

Materials:

* 4 Lengths of twenty six Inch 1×2 Cedar

* 4 Lengths of thirteen Inch 1×2 Cedar

* Twelve End and Side Panels five ½ Inches x twelve ¼

* Two Base Panels one Inch x six Inches x twenty four Inches

* Timber glue

* Galvanized nails

* Hammer

* Stainless-steel and/or Ceramic Coated Screws

* Drill driver and bits

Speed square Note: All our sections were precut, therefore they simply need assembly. In case you cannot and do not want to reduce your own personal lumber, home supply stores will typically cut it suitable for you for a small charge.

Expert tip: Before you start hammering, use sandpaper to rough up the striking surface area of the hammer of yours. Well then it is not as likely to slip while you are working.

Building the Frames Build the bottom and top frames from the 1×2 cedar strips. You will be butting the ends together, therefore no mitering is essential.

Fasten 2 26″ strips to 2 13″ strips to create each rectangular frame. (You’ll have to make sure that the length remains 26″; to do this, but the ends of the shorter strip against the lengthier strips. The thickness of the 2 longer strips will lend an inch to each end of the smaller strips, boosting the measurements of theirs to 16″. Do this at each end of the lengthier strips to create a rectangular frame 26″ long and 16″ wide.)

Sharing is caring!

shares